falentino. glass door. February 26th , 2018.
Having a refrigerator with glass doors can even help you find things easier when you need them. You will want to keep the refrigerator shelves neat because they will be so visible. No more throwing items into the refrigerator or putting unattractively wrapped leftovers on one of the shelves. The benefit is a nice neat refrigerator all of the time allowing you to find what you need as well.
The first thing we have to do is measure for the replacement door. You want to measure across the bottom, center, and top of the existing door frame to find the narrowest dimension. Start outside and measure at the point where the old door frame stops and the exterior material starts. That material can be stucco, siding, or brick. Measure across in the 3 places: bottom, center, and top. Record the smallest dimension. Then go inside and do the same thing. You want to measure where the frame ends and the drywall, plaster, or sheetrock begins. Take all six measurements, find the narrowest one, and deduct 3/4". That is the width of the new door. Now, when you measure the height, you can do it just on the outside. Measure the left, center, and right side from the ground where the bottom track sits, up to the top where the old frame ends and the exterior material begins. Take the narrowest dimension and deduct 1/2". That is your height of the new door. Then, determine which side the sliding panel should be on. The fixed panel is designated by the letter "O", and the slider is an "X". In most areas of the country, you call it out by looking at the door from outside and reading left to right. So, if you were outside looking at your door, and you want the sliding panel to close to the right wall, you would ask for an "OX". However, because i have recently discovered that not all parts of the country do it this way, my suggestion is to ask the dealer how they read the opening before placing your order.
Modern digital printing now also enables glass doors to be patterned or to have designs added. This is less useful for homes, but for businesses and commercial properties it provides the opportunity to have company logos or other relevant information included on the glass.
Your first step is to remove the the old handle and then clean the area from which you removed it. If glue or any other type of adhesive was used on the old one, make sure that any remaining matter is scraped off to allow the new door handle to be installed as smooth as possible. Next, make sure that the holes on the door itself are of equal distance with the holes on the new glass handle. If the holes match, proceed to drill in the screws. If new ones need to be drilled, mark the surface with a pencil where you wish to place the new screws. If you are installing a glass handle that does not require screws, you may use an adhesive to install the new handle. Make sure that that you use a strong water proof adhesive that will withstand heat and steam. After you′ve applied the adhesive and have installed the new glass handle, do not use the handle for several hours until the handle is firmly secured.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.