glass door. Monday , February 26th , 2018 - 13:51:25 PM
Difficult to Install - This is one of the projects that I would seriously recommend you hire a licensed contractor to install. Most manufacturers only sell the product as an installed unit because of the difficulty of installing them; they require all installers to be factory trained employees. Even manufacturers that don′t install, usually require vendors to be licensed glaziers.
You want to be sure and order all of the materials you will need to do the job at the same time that you order the replacement door. That way, when the new door comes in 2 to 4 weeks later, you will have everything ready to do the job. In addition to any trim needed, you are also going to need caulk, a roll of R-13 Insulation, liquid nails for the track, 4" deck screws, shims, dust masks, and safety glasses. Once the new door arrives, it will be time to take out the old door. That will be our topic in next week′s article.
While you′re at it, clean up all the "mating-edges" of the door. This is where the sliding door meets with any other surface of the door frame. A general rule of thumb is to simply wipe down anything that looks dirty. Remember, even if the dirt is not necessarily in the track itself, it can eventually fall to the track causing your door to require another wipe down. If you notice any mating edges that feel sticky, take a paper towel and spray some oil into it, then wipe the oil onto the sticky surfaces.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.