glass door. Monday , February 26th , 2018 - 13:48:21 PM
The first thing we have to do is measure for the replacement door. You want to measure across the bottom, center, and top of the existing door frame to find the narrowest dimension. Start outside and measure at the point where the old door frame stops and the exterior material starts. That material can be stucco, siding, or brick. Measure across in the 3 places: bottom, center, and top. Record the smallest dimension. Then go inside and do the same thing. You want to measure where the frame ends and the drywall, plaster, or sheetrock begins. Take all six measurements, find the narrowest one, and deduct 3/4". That is the width of the new door. Now, when you measure the height, you can do it just on the outside. Measure the left, center, and right side from the ground where the bottom track sits, up to the top where the old frame ends and the exterior material begins. Take the narrowest dimension and deduct 1/2". That is your height of the new door. Then, determine which side the sliding panel should be on. The fixed panel is designated by the letter "O", and the slider is an "X". In most areas of the country, you call it out by looking at the door from outside and reading left to right. So, if you were outside looking at your door, and you want the sliding panel to close to the right wall, you would ask for an "OX". However, because i have recently discovered that not all parts of the country do it this way, my suggestion is to ask the dealer how they read the opening before placing your order.
May require a general contractor - Most times when installing a multi-slide door, it may require framing changes. Depending on where you live, if the change is made to a load bearing wall, you have to pull a permit and have an engineer sign off on the change. This will usually require a GC to handle the details for you. A simple French door or window installation can be done by a licensed window or door company. Cost - These doors can be quite expensive. Most time when I give a remodeling customer / homeowner an estimate on these doors, it usually becomes price prohibitive. They see a French door or sliding glass door at a home store for 800 dollars and figure these doors are three times as big, so they should be three times as much right? Wrong, you see standard size doors are made with stock sized tempered glass. Multi-slide doors are custom sized and the price grown exponentially when you go to custom sizes.
There are many advantages that come with using sliding glass doors to complete interior design projects. They are lightweight, simple to use and require less space for opening and closing. You can also allow a significant amount of sunlight into a room without the drawbacks of experiencing cold, heat or wind. Additionally, glass doors are sturdy and do not need to be replaced often because they are designed to last for years or even decades.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.