glass door. Monday , February 26th , 2018 - 13:23:55 PM
The first thing we have to do is measure for the replacement door. You want to measure across the bottom, center, and top of the existing door frame to find the narrowest dimension. Start outside and measure at the point where the old door frame stops and the exterior material starts. That material can be stucco, siding, or brick. Measure across in the 3 places: bottom, center, and top. Record the smallest dimension. Then go inside and do the same thing. You want to measure where the frame ends and the drywall, plaster, or sheetrock begins. Take all six measurements, find the narrowest one, and deduct 3/4". That is the width of the new door. Now, when you measure the height, you can do it just on the outside. Measure the left, center, and right side from the ground where the bottom track sits, up to the top where the old frame ends and the exterior material begins. Take the narrowest dimension and deduct 1/2". That is your height of the new door. Then, determine which side the sliding panel should be on. The fixed panel is designated by the letter "O", and the slider is an "X". In most areas of the country, you call it out by looking at the door from outside and reading left to right. So, if you were outside looking at your door, and you want the sliding panel to close to the right wall, you would ask for an "OX". However, because i have recently discovered that not all parts of the country do it this way, my suggestion is to ask the dealer how they read the opening before placing your order.
Difficult to Install - This is one of the projects that I would seriously recommend you hire a licensed contractor to install. Most manufacturers only sell the product as an installed unit because of the difficulty of installing them; they require all installers to be factory trained employees. Even manufacturers that don′t install, usually require vendors to be licensed glaziers.
The number 1 reason why your sliding glass door won′t side is because too much dirt and debris have clogged up the wheels and the track of your door panel. This is not a hard fix, but because most sliding glass doors are quite heavy, it is best if you have another person present to help you. The first step is to examine how your sliding glass door is fixed to the track. The majority of sliding glass doors have a strip that runs along the top of the frame that holds the doors in vertical alignment, positioning the wheels to fit neatly over the sliding track. To begin, let′s use a simple screwdriver to remove that strip at the top. Once the strip is removed, slowly tilt the door out of the frame, then remove it out of the frame all-together. Turn the door on its side and examine the wheels at the bottom of the door. Remember, some sliding glass doors can be upwards of 90 pounds, so either acquire some help or be very confident in your physical ability.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.