glass door. Monday , February 26th , 2018 - 13:25:43 PM
This article is going to be about replacing an old sliding glass door with a modern Vinyl frame sliding glass door. If you currently have french doors and you want to replace them with sliding doors, or vise versa, future articles will cover that topic.
You want to be sure and order all of the materials you will need to do the job at the same time that you order the replacement door. That way, when the new door comes in 2 to 4 weeks later, you will have everything ready to do the job. In addition to any trim needed, you are also going to need caulk, a roll of R-13 Insulation, liquid nails for the track, 4" deck screws, shims, dust masks, and safety glasses. Once the new door arrives, it will be time to take out the old door. That will be our topic in next week′s article.
Once the door is on its side, you can closely examine the wheels and the track. Most commonly, you will find the wheels are full of soot and debris, and the track is also likely very dirty. To clean the wheels, use compressed air and needle tip pliers. Be careful to pull every last hair out of the wheel bearings. It is wise to be diligent in this step, so you don′t have to make a habit of this process. Once the wheels are completely clean, spray a little bit of penetrating oil into the wheel bearings, spinning the wheel as you apply the oil. (The best choice for the oil is DuPont′s Teflon non-stick dry film lubricant.) It is equally important to clean the track that the wheels rest on. Use damp paper towels to remove the grit and dirt, and then spray the penetrating oil along the track so it is well-applied. Use a clean paper towel to ensure it is evenly applied.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.