glass door. Monday , February 26th , 2018 - 13:23:29 PM
Once you have purchased a glass door handle and have determined that all the pieces are included in the handle set, you are ready to start installing the piece. Before you start installation though, be sure an instruction sheet is included in the sheet. More often than not, you may not have to use these instructions. If you have never installed a glass handle, you will need the instructions. More often than not, you will be replacing a handle that′s already in place. If the glass handle you′re installing is identical or similar to the one you′re replacing, you may not need the instructions and will be able to do the installation within minutes. Here is an example of how to replace a glass door handle on a glass shower door.
Next, you have to decide whether you want a retrofit frame or a replacement frame. If the old frame is flush with the exterior material, such as in the case of stucco, then you want to get the retrofit frame, which comes with the outside fin. That will eliminate the need to trim the outside. If you have brick or siding surrounding the opening, then you need to get a replacement frame and trim the outside yourself. You can use wood, vinyl, or other composite materials available in most major hardware store chains. You also need to measure the depth of the old frame. The majority of vinyl replacement doors have a frame depth of 4 3/4". Most door openings, when framed, have a depth of 5 1/2" to the innermost surface of the wall, whether it′s drywall, plaster, or whatever else. Therefore, when you install the new door, you will need to add some sort of trim product to build the inside of the door frame so it is flush with the wall surface.
Once the door is on its side, you can closely examine the wheels and the track. Most commonly, you will find the wheels are full of soot and debris, and the track is also likely very dirty. To clean the wheels, use compressed air and needle tip pliers. Be careful to pull every last hair out of the wheel bearings. It is wise to be diligent in this step, so you don′t have to make a habit of this process. Once the wheels are completely clean, spray a little bit of penetrating oil into the wheel bearings, spinning the wheel as you apply the oil. (The best choice for the oil is DuPont′s Teflon non-stick dry film lubricant.) It is equally important to clean the track that the wheels rest on. Use damp paper towels to remove the grit and dirt, and then spray the penetrating oil along the track so it is well-applied. Use a clean paper towel to ensure it is evenly applied.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.