glass door. Monday , February 26th , 2018 - 13:30:38 PM
After you′ve done all this, reinstall the door. You should notice right away that the door is much easier to slide, and should require significantly less effort. If for any reason the door is still difficult to roll, it is likely one of the following reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the track, and is thus hitting the top plate of the door frame. If your wheels are burned out, unfortunately you′ll have to call the manufacture of your sliding glass door and request new wheels. If, on the other hand, your door is hitting the top plate of your door frame, you can adjust this by finding the screw holes at the very bottom of you sliding glass door. On most sliding glass doors, there are two screws which can be turned with either a flathead screwdriver or an alan wrench. Turn to the right to raise the door, or turn to the left to lower the door.
While you′re at it, clean up all the "mating-edges" of the door. This is where the sliding door meets with any other surface of the door frame. A general rule of thumb is to simply wipe down anything that looks dirty. Remember, even if the dirt is not necessarily in the track itself, it can eventually fall to the track causing your door to require another wipe down. If you notice any mating edges that feel sticky, take a paper towel and spray some oil into it, then wipe the oil onto the sticky surfaces.
Once the door is on its side, you can closely examine the wheels and the track. Most commonly, you will find the wheels are full of soot and debris, and the track is also likely very dirty. To clean the wheels, use compressed air and needle tip pliers. Be careful to pull every last hair out of the wheel bearings. It is wise to be diligent in this step, so you don′t have to make a habit of this process. Once the wheels are completely clean, spray a little bit of penetrating oil into the wheel bearings, spinning the wheel as you apply the oil. (The best choice for the oil is DuPont′s Teflon non-stick dry film lubricant.) It is equally important to clean the track that the wheels rest on. Use damp paper towels to remove the grit and dirt, and then spray the penetrating oil along the track so it is well-applied. Use a clean paper towel to ensure it is evenly applied.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.