glass door. Monday , February 26th , 2018 - 05:23:41 AM
Once you have purchased a glass door handle and have determined that all the pieces are included in the handle set, you are ready to start installing the piece. Before you start installation though, be sure an instruction sheet is included in the sheet. More often than not, you may not have to use these instructions. If you have never installed a glass handle, you will need the instructions. More often than not, you will be replacing a handle that′s already in place. If the glass handle you′re installing is identical or similar to the one you′re replacing, you may not need the instructions and will be able to do the installation within minutes. Here is an example of how to replace a glass door handle on a glass shower door.
The first thing we have to do is measure for the replacement door. You want to measure across the bottom, center, and top of the existing door frame to find the narrowest dimension. Start outside and measure at the point where the old door frame stops and the exterior material starts. That material can be stucco, siding, or brick. Measure across in the 3 places: bottom, center, and top. Record the smallest dimension. Then go inside and do the same thing. You want to measure where the frame ends and the drywall, plaster, or sheetrock begins. Take all six measurements, find the narrowest one, and deduct 3/4". That is the width of the new door. Now, when you measure the height, you can do it just on the outside. Measure the left, center, and right side from the ground where the bottom track sits, up to the top where the old frame ends and the exterior material begins. Take the narrowest dimension and deduct 1/2". That is your height of the new door. Then, determine which side the sliding panel should be on. The fixed panel is designated by the letter "O", and the slider is an "X". In most areas of the country, you call it out by looking at the door from outside and reading left to right. So, if you were outside looking at your door, and you want the sliding panel to close to the right wall, you would ask for an "OX". However, because i have recently discovered that not all parts of the country do it this way, my suggestion is to ask the dealer how they read the opening before placing your order.
While you′re at it, clean up all the "mating-edges" of the door. This is where the sliding door meets with any other surface of the door frame. A general rule of thumb is to simply wipe down anything that looks dirty. Remember, even if the dirt is not necessarily in the track itself, it can eventually fall to the track causing your door to require another wipe down. If you notice any mating edges that feel sticky, take a paper towel and spray some oil into it, then wipe the oil onto the sticky surfaces.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.