glass door. Monday , February 26th , 2018 - 04:26:58 AM
May require a general contractor - Most times when installing a multi-slide door, it may require framing changes. Depending on where you live, if the change is made to a load bearing wall, you have to pull a permit and have an engineer sign off on the change. This will usually require a GC to handle the details for you. A simple French door or window installation can be done by a licensed window or door company. Cost - These doors can be quite expensive. Most time when I give a remodeling customer / homeowner an estimate on these doors, it usually becomes price prohibitive. They see a French door or sliding glass door at a home store for 800 dollars and figure these doors are three times as big, so they should be three times as much right? Wrong, you see standard size doors are made with stock sized tempered glass. Multi-slide doors are custom sized and the price grown exponentially when you go to custom sizes.
You want to be sure and order all of the materials you will need to do the job at the same time that you order the replacement door. That way, when the new door comes in 2 to 4 weeks later, you will have everything ready to do the job. In addition to any trim needed, you are also going to need caulk, a roll of R-13 Insulation, liquid nails for the track, 4" deck screws, shims, dust masks, and safety glasses. Once the new door arrives, it will be time to take out the old door. That will be our topic in next week′s article.
Next, you have to decide whether you want a retrofit frame or a replacement frame. If the old frame is flush with the exterior material, such as in the case of stucco, then you want to get the retrofit frame, which comes with the outside fin. That will eliminate the need to trim the outside. If you have brick or siding surrounding the opening, then you need to get a replacement frame and trim the outside yourself. You can use wood, vinyl, or other composite materials available in most major hardware store chains. You also need to measure the depth of the old frame. The majority of vinyl replacement doors have a frame depth of 4 3/4". Most door openings, when framed, have a depth of 5 1/2" to the innermost surface of the wall, whether it′s drywall, plaster, or whatever else. Therefore, when you install the new door, you will need to add some sort of trim product to build the inside of the door frame so it is flush with the wall surface.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.