glass door. Sunday , February 25th , 2018 - 20:06:26 PM
The first thing we have to do is measure for the replacement door. You want to measure across the bottom, center, and top of the existing door frame to find the narrowest dimension. Start outside and measure at the point where the old door frame stops and the exterior material starts. That material can be stucco, siding, or brick. Measure across in the 3 places: bottom, center, and top. Record the smallest dimension. Then go inside and do the same thing. You want to measure where the frame ends and the drywall, plaster, or sheetrock begins. Take all six measurements, find the narrowest one, and deduct 3/4". That is the width of the new door. Now, when you measure the height, you can do it just on the outside. Measure the left, center, and right side from the ground where the bottom track sits, up to the top where the old frame ends and the exterior material begins. Take the narrowest dimension and deduct 1/2". That is your height of the new door. Then, determine which side the sliding panel should be on. The fixed panel is designated by the letter "O", and the slider is an "X". In most areas of the country, you call it out by looking at the door from outside and reading left to right. So, if you were outside looking at your door, and you want the sliding panel to close to the right wall, you would ask for an "OX". However, because i have recently discovered that not all parts of the country do it this way, my suggestion is to ask the dealer how they read the opening before placing your order.
After you′ve done all this, reinstall the door. You should notice right away that the door is much easier to slide, and should require significantly less effort. If for any reason the door is still difficult to roll, it is likely one of the following reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the track, and is thus hitting the top plate of the door frame. If your wheels are burned out, unfortunately you′ll have to call the manufacture of your sliding glass door and request new wheels. If, on the other hand, your door is hitting the top plate of your door frame, you can adjust this by finding the screw holes at the very bottom of you sliding glass door. On most sliding glass doors, there are two screws which can be turned with either a flathead screwdriver or an alan wrench. Turn to the right to raise the door, or turn to the left to lower the door.
Glass doors are the ideal way to create the illusion of space in your home. You could also consider custom made glass doors depending on the design elements in your home. For example you could have wooden door fitted with stained or patterned glass to create a unique design. Whatever your preference, there′s an option for you.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.