The first thing we have to do is measure for the replacement door. You want to measure across the bottom center and top of the existing door frame to find the narrowest dimension. Start outside and measure at the point where the old door frame stops and the exterior material starts. That material can be stucco siding or brick. Measure across in the 3 places: bottom center and top. Record the smallest dimension. Then go inside and do the same thing. You want to measure where the frame ends and the drywall plaster or sheetrock begins. Take all six measurements find the narrowest one and deduct 3/4". That is the width of the new door. Now when you measure the height you can do it just on the outside. Measure the left center and right side from the ground where the bottom track sits up to the top where the old frame ends and the exterior material begins. Take the narrowest dimension and deduct 1/2". That is your height of the new door. Then determine which side the sliding panel should be on. The fixed panel is designated by the letter "O" and the slider is an "X". In most areas of the country you call it out by looking at the door from outside and reading left to right. So if you were outside looking at your door and you want the sliding panel to close to the right wall you would ask for an "OX". However because i have recently discovered that not all parts of the country do it this way my suggestion is to ask the dealer how they read the opening before placing your order.
Tags: beer refrigerator glass door. hanging sliding glass doors. glass overhead door. entry door glass replacement. glass door las vegas. commercial fridge glass door. sliding glass door replacement cost. replace a sliding glass door.
Have Something to Say on
Graphics and other visual elements, as well as any sign reproduced on the display products reproduced on the Website belong to their respective owners and users and cannot be used without the prior and written approval of their respectiv owners. Copyright © 2004–2018 youdopia.