glass door. Sunday , February 25th , 2018 - 16:46:47 PM
After you′ve done all this, reinstall the door. You should notice right away that the door is much easier to slide, and should require significantly less effort. If for any reason the door is still difficult to roll, it is likely one of the following reasons: either your wheels are completely burned out, or your sliding glass door is sitting too high on the track, and is thus hitting the top plate of the door frame. If your wheels are burned out, unfortunately you′ll have to call the manufacture of your sliding glass door and request new wheels. If, on the other hand, your door is hitting the top plate of your door frame, you can adjust this by finding the screw holes at the very bottom of you sliding glass door. On most sliding glass doors, there are two screws which can be turned with either a flathead screwdriver or an alan wrench. Turn to the right to raise the door, or turn to the left to lower the door.
When it comes to keeping your house in tip-top shape, nothing can be more annoying than a sliding glass door that won′t slide. After all, what′s the purpose of having a beautiful glass door that leads out to a picturesque backyard if the darn thing takes three NFL linebackers to slide it open? So having personally experienced such sliding glass door angst, I decided to write this article to inform you on the number 1 reason why your sliding glass door won′t slide - and what you can do about it!
Your first step is to remove the the old handle and then clean the area from which you removed it. If glue or any other type of adhesive was used on the old one, make sure that any remaining matter is scraped off to allow the new door handle to be installed as smooth as possible. Next, make sure that the holes on the door itself are of equal distance with the holes on the new glass handle. If the holes match, proceed to drill in the screws. If new ones need to be drilled, mark the surface with a pencil where you wish to place the new screws. If you are installing a glass handle that does not require screws, you may use an adhesive to install the new handle. Make sure that that you use a strong water proof adhesive that will withstand heat and steam. After you′ve applied the adhesive and have installed the new glass handle, do not use the handle for several hours until the handle is firmly secured.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.