glass door. Sunday , February 25th , 2018 - 16:26:02 PM
The first thing we have to do is measure for the replacement door. You want to measure across the bottom, center, and top of the existing door frame to find the narrowest dimension. Start outside and measure at the point where the old door frame stops and the exterior material starts. That material can be stucco, siding, or brick. Measure across in the 3 places: bottom, center, and top. Record the smallest dimension. Then go inside and do the same thing. You want to measure where the frame ends and the drywall, plaster, or sheetrock begins. Take all six measurements, find the narrowest one, and deduct 3/4". That is the width of the new door. Now, when you measure the height, you can do it just on the outside. Measure the left, center, and right side from the ground where the bottom track sits, up to the top where the old frame ends and the exterior material begins. Take the narrowest dimension and deduct 1/2". That is your height of the new door. Then, determine which side the sliding panel should be on. The fixed panel is designated by the letter "O", and the slider is an "X". In most areas of the country, you call it out by looking at the door from outside and reading left to right. So, if you were outside looking at your door, and you want the sliding panel to close to the right wall, you would ask for an "OX". However, because i have recently discovered that not all parts of the country do it this way, my suggestion is to ask the dealer how they read the opening before placing your order.
Once the door is on its side, you can closely examine the wheels and the track. Most commonly, you will find the wheels are full of soot and debris, and the track is also likely very dirty. To clean the wheels, use compressed air and needle tip pliers. Be careful to pull every last hair out of the wheel bearings. It is wise to be diligent in this step, so you don′t have to make a habit of this process. Once the wheels are completely clean, spray a little bit of penetrating oil into the wheel bearings, spinning the wheel as you apply the oil. (The best choice for the oil is DuPont′s Teflon non-stick dry film lubricant.) It is equally important to clean the track that the wheels rest on. Use damp paper towels to remove the grit and dirt, and then spray the penetrating oil along the track so it is well-applied. Use a clean paper towel to ensure it is evenly applied.
Having a refrigerator with glass doors can even help you find things easier when you need them. You will want to keep the refrigerator shelves neat because they will be so visible. No more throwing items into the refrigerator or putting unattractively wrapped leftovers on one of the shelves. The benefit is a nice neat refrigerator all of the time allowing you to find what you need as well.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does youdopia claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.